How do I prevent a WCF service from enter a faulted state?

I have a WCF Service that should not enter the faulted state. If there's an exception, it should be logged and the service should continue uninterrupted. The service has a one-way operation contract and is reading messages from an MSMQ.

My problems are twofold:

  1. The service appears to be swallowing an exception/fault so I am unable to debug it. How do I get the service to expose the exception so that I can log or handle it?
  2. The service is entering into a faulted state after this exception is swallowed. How do I prevent the service from entering into a faulted state?


Most, if not all exceptions can be seen in the WCF Trace (Configuring Tracing) and the trace is best viewed with the Service Trace Viewer.

Obviously, this is not something you should have running all day in a production environment, but it helps in troubleshooting anyway.

Apart from that, note that oneways may not run as a true "fire and forget" depending on the SessionMode you use. If you have your service configured for SessionMode.Allowed or even SessionMode.Required, the oneway operation will run as if it was not oneway at all (this can be observed when using oneways over the netTcpBinding). To be frank, however, I don't know if that changes the type of exceptions you can get, or when you get them. However, in any case, you should get an exception if the request could not be send at all. AFAIK, the oneway "ends" when it is successfully enqued on the server side. So there is some place for (WCF framework related) exceptions until then (serialization/deserialization comes to mind).

Then, such framework related exceptions are best seen (even an IErrorHandler doesn't get them all due to the fact when it is called in the request/response-flow) using the above mentioned trace / traceviewer.

The official documentation on how to handle Faults is here:

with the main page being at Channel Model Overview

There's a nice state diagram showing how things happen:

Need Your Help

Using Python's pickle in Sage results in high memory usage

python memory-management sage

I am using the Python based Sage Mathematics software to create a very long list of vectors. The list contains roughly 100,000,000 elements and sys.getsizeof() tells me that it is of size a little ...

How to use dynamic id in jquery

javascript jquery hover

I am using this to point a seperate td's in a table. And the id(dynid) are created dynamically so i need to change the position to absolute when user hover on a td. And i tries the below one but it...